Thomas_A skrev:Hej!
Har ett par "tunga" spolar som ligger på 1.4 mm tråd och 3.0 mH. Skulle vilja ha 2.4 mH men drar mig för att köpa just nu. Tänkte dock om det är möjligt att linda av och i så fall går det att räkna på hur många varva jag bör linda av för att komma til ca 2.4 mH?
Spolarna är dock lite olika, en Jentzen som är relativt hög och en som är lindad på en plastrulle som är "liggande" format.
vh/T
Passa på att göra som Snell acoustics, mäta upp individuella element då du ändå håller på och lindar av spolar.
”The Type E/III's crossover employs high-quality non-polarized electrolytic capacitors, Mylar capacitors, and air-core inductors. The crossover design was created with a computer program after each driver had been measured in the very cabinet used in production. Once designed, the actual manufacturing process involves tuning each speaker's frequency response, with grilles in place, to within 0.5dB of a standard, called the "reference master." This tolerance is far better than the ±4–5dB quoted by the vendors supplying the drivers. Each speaker is trimmed by a "specialist," who spends most of his time at the Snell plant just matching loudspeakers to the reference master. This is done by overwinding inductors, and then pulling turns off, one at a time; starting with smaller capacitor values, and adding trimmers; and finally, adjusting variable resistors. The tweeter-level control is also calibrated against the reference master. These final speaker adjustments require 20 minutes' labor for each Type E/III produced.”
Read more at
https://www.stereophile.com/floorloudsp ... wGg7cQC.99