har haft ett lite klent slutsteg innan men nu har ett T.AMP TA1050 MK-X
införskaffats
och förhoppningen var att jag ska kunna använda dom basar jag har..
i mindre lådor med LT
har surfat runt lite på nätet och hittade det här
Guidelines
With the explanation and examples out of the way, you might be wondering what kind of specs to look for when choosing a driver. Here are some guidelines that should help you.
Look for a driver with a BIG linear Xmax. The driver should have a one-way Xmax of over 12 mm (0.5"). OK, Med marginal 12,1mm
Look for a driver that is 300 mm (12 inches) or bigger. Remember, that producing low frequencies is all about displacing large quantities of air. OK
The driver should have a high power handling capability, in my opinion at least 300 watts RMS. The driver will need a lot of power to hit those low frequencies. OK
The driver should also have a low Fs. OK
And finally the driver should have a high sensitivity rating, är väl kanske inte det bästa 87.71 1W/1m
är det något som kan funka
provade att ladda hem basta och räknade lite på det.
någon som har någon erfarenhet av LT?
Data på basen
Free Air Resonance (Fs): 20.9 Hz
Electrical “Q” (Qes): 0.406
Mechanical “Q” (Qms): 6.936
Total Speaker “Q” (Qts): 0.384
Equivalent Compliance (Vas): 173.51 litres
One-way, Linear Excursion (Xmax):12.1 mm
Efficiency (1W/1m): 87.71 dB
Effective Piston Area (Sd): 0.0682 sq. m.
DC Resistance (Re): 4.114 ohm
Nominal Impedance: 4 ohm
Power Handling (continuous): 350W
